Pedestrian-Activated Lighting

Arduino-based Smart City Model
Smart City Road Model with Pedestrian Lighting

This project demonstrates a smart street lighting system where pedestrian interaction activates road lights. Inspired by piezoelectric energy-generating sidewalks used in Japan, the model simulates pressure detection using push buttons connected to an Arduino UNO. When a pedestrian presses either sidewalk button, street lights automatically turn on for a fixed duration to improve safety and energy efficiency.

Control Flow

Pedestrian Button Press
Arduino Input Detection
Signal Processing (INPUT_PULLUP)
LED Control Loop
Lights Activated (3s)

Hardware

  • Arduino UNO
  • Custom PCB Push Buttons
  • LEDs (6 street lights)
  • Current-limiting resistors (220Ω)
  • Breadboard & Jumper wires
  • USB Power Supply

Circuit

  • Each LED connects to a digital output pin.
  • Circuits use 220Ω resistors for protection.
  • Physical buttons are wired in parallel.
  • Uses internal pull-up (INPUT_PULLUP) to prevent floating pins.

System Logic

1. Trigger
Pedestrian presses sidewalk tile (simulated via push button).
2. Detect
Arduino detects a LOW signal dropping against the internal pull-up resistor.
3. Activate
Arduino outputs HIGH to all LED street light pins simultaneously.
4. Duration
Lights remain illuminated for a fixed safety duration of 3 seconds.
5. Reset
System automatically shuts off lighting, conserving power until the next trigger.

Firmware

The logic relies on INPUT_PULLUP, meaning the unpressed state reads as HIGH. When a button is pressed, the circuit connects to ground, dropping the pin to a LOW state to trigger the lighting loop.

smart_lighting.ino
#define BUTTON_PIN 2 // Array to manage 6 street light LEDs int streetLights[] = {3, 4, 5, 6, 7, 8}; int numLights = 6; void setup() { // Internal pull-up ensures stable HIGH state when unpressed pinMode(BUTTON_PIN, INPUT_PULLUP); for (int i = 0; i < numLights; i++) { pinMode(streetLights[i], OUTPUT); digitalWrite(streetLights[i], LOW); // Ensure off at startup } } void loop() { // LOW signal indicates button press (connected to GND) if (digitalRead(BUTTON_PIN) == LOW) { // Activate all street lights for (int i = 0; i < numLights; i++) { digitalWrite(streetLights[i], HIGH); } delay(3000); // Maintain illumination for 3 seconds // Deactivate lights for (int i = 0; i < numLights; i++) { digitalWrite(streetLights[i], LOW); } } }

Features

  • Energy efficient lighting
  • Pedestrian safety focused
  • Real-world smart city inspiration
  • Low-cost hardware implementation
  • Highly expandable system

Scalability

  • Integration of real piezoelectric sensors
  • Solar-powered independent lighting nodes
  • Automatic night detection (via LDR)
  • Wireless monitoring dashboard

Conclusion

This project demonstrates how simple embedded systems can simulate smart city infrastructure. By combining pedestrian input with automated lighting control, the design highlights energy efficiency and urban safety concepts, proving that scalable logic can be prototyped using highly accessible microcontrollers.